Learning a new process...

I recently purchased a Cricut Maker to incorporate into my pottery.  Here's a few snapshots of just a few of the steps that go into making a mug.  This started from a blob of clay.  Several steps were completed before the steps in these photos.  Cut paper resist design is applied to greenware.  Coloured slip is coated over the paper resist.  The resist is removed revealing the design.  Glaze is then applied and off to kiln to a whopping temperature of 2232 Farenheit (cone 6).

Check out the finished mug.  I will have 4 of these listed for sale in the coming week or so.